Easton X10 Shafts - Doz

Easton X10 Shafts - Doz

Easton x10 shafts, Easton's top of the range shaft. A slightly heavier arrow but with a very small diameter gives this shaft a high performance. The perfect 10 hands down. Small diameter barrelled profile resists wind drift better than any other type of arrow.

• High-strength carbon fiber bonded to a 7075 alloy core
• 9-micron polished carbon finish
• Guaranteed straightness: ±.0015”
• Weight tolerance: ± 0.5 grains

Arrow Length

The Easton X10 uses a large groove G-Pin nock as standard, unless you specify that you are using a nock different to this then we will cut the arrow using a large groove G-Pin nock. If you use a different nock to standard then please mention this in the 'Comments/Feedback?:’ box which is at the bottom of the ‘checkout’ page.

When entering your required arrow / shaft length please enter the AMO length - this is the length of the arrow from the inside of the nock to the end of the shaft (Excluding the point). Please refer to the below diagram as an example.

If you already have a set of arrows / shafts you can send in one and we will use you sample arrow to set up our saw to ensure the length of the arrows match perfectly.

Stock Status: Usually in Stock

View CORRECT ARROW MEASUREMENT
View more products from "Arrows & Component Parts"
View more products from "Easton Carbon Arrows & Component Parts"
View more products from "Easton Carbon Shafts"

Shipping Band E (£8.40)

£348.00 ($463.15 Approx)